The Logic and Technique of Watering
Watering should moisten the root ball evenly, keep air in it, and let excess water drain away. How often and how much you water depends on the substrate, the pot, light, temperature, humidity, and the condition of the roots.
What happens after watering
Water wets the substrate and fills its pores. Some of the moisture is held by the particles of the medium, and the excess moves down and drains out through the drainage holes. Once it has drained, the large pores fill with air again.
Roots take up water and nutrients only where moisture and oxygen are available at the same time. That is why the same volume of water can be beneficial in a loose, warm substrate and dangerous in a dense, cold, or slow-drying mix.
Water should spread through the entire root ball. If it wets only a narrow zone along the wall, the middle can stay dry.
Why watering is not done by the calendar
The same pot can dry out in a few days in summer under a lamp, and in winter on a cool windowsill stay moist for more than a week. The drying rate is affected by:
- light and the activity of growth;
- the temperature of the air and the substrate;
- humidity and air movement;
- the size of the plant and its leaf area;
- the volume, shape, and material of the pot;
- the composition of the substrate;
- the number and condition of the roots.
In warm, bright conditions a plant uses water faster. With a lack of light, coolness, high humidity, or damaged roots, watering is needed less often.
Watering from above
Water is spread slowly over the whole surface, with pauses to let it soak in. Watering continues until the root ball is evenly moist and a moderate amount of water runs out of the drainage holes.
The first drops from the drainage holes do not prove that the whole substrate is wet. In a loose mix, water can pass quickly through the large pores and come out at the bottom while part of the root ball stays dry.
If the water runs down the walls and the middle stays dry, moisten the surface slightly and repeat the watering in small portions. Severely dried peat and coir sometimes have to be rewetted gradually.
Direct the water onto the substrate, without flooding the leaves and the growing point unless necessary.
Watering through until water drains
Watering thoroughly from time to time helps soak the substrate evenly, remove some of the accumulated salts, and check that the drainage holes are not blocked.
Once it has drained, the excess water is removed from the saucer or cachepot. Constant contact between the pot and water is acceptable only in systems with a properly designed reservoir and enough air reaching the roots.
Bottom watering
With bottom watering, the pot is placed in a container of water for a limited time so that moisture rises through the capillaries. This method is convenient for plants with a sensitive growing point or a substrate surface that is easily washed away.
After the water has been absorbed, the pot is taken out and the excess is allowed to drain. From time to time the substrate is watered through from above to moisten the upper part and carry salts out.
Water temperature and quality
The water should be close to the air temperature in the room. Cold water on a cold substrate slows the roots down and increases stress.
For regular watering, use water whose mineral content and pH suit the plant and the chosen substrate. Between feedings, plain water without fertilizer is used.
Watering and feeding
A solution with fertilizer is watering and feeding at the same time. Its concentration is chosen taking into account the source water, the substrate, the growth stage, light, and temperature.
A frequent weak solution can be gentler than an infrequent concentrated feeding, but salts must still be monitored and periodically flushed out with plain water. Excess salts make water uptake harder and can cause slowed growth, loss of turgor, and drying leaf edges.
After repotting
After repotting, the way you water depends on the condition of the roots and the moisture of the new mix. A healthy plant is usually watered evenly so that the substrate settles against the roots.
After rot has been removed or the roots have been cut back heavily, excessive watering does not help recovery. Moderate moisture, warmth, and air in the substrate matter more.
Common mistakes
- pouring water quickly onto one spot;
- taking the first drops from the drainage holes as a sign of complete soaking;
- leaving the pot standing in water without a designed system;
- watering with ice-cold water;
- using a concentrated fertilizer solution for flushing;
- constantly using only bottom watering;
- flooding the leaves and the growing point unless necessary.
The watering technique must match the substrate, the pot, and the condition of the roots. The same method can be safe for a loose mix and lead to waterlogging in a dense root ball.