Water: Sources, Mineral Content, and Hardness
Water is part of a plant's nutrition system. It does not just moisten the substrate — it also brings calcium, magnesium, sodium, chlorides, bicarbonates, and other dissolved substances. Its composition affects the starting EC, how fertilizers work, the stability of pH, and how quickly salts build up.
The same source does not guarantee the same water quality: values can change between districts, seasons, and even after repairs to the water mains. So you go by the water's measurable composition, not by its name.
What matters about water
For routine care it is useful to distinguish four parameters:
| Parameter | What it shows |
|---|---|
| pH | How acidic or alkaline the water is |
| EC | Overall electrical conductivity, related to the amount of dissolved ions |
| Hardness (GH) | Mainly the calcium and magnesium content |
| Alkalinity (KH) | The water's ability to resist a change in pH |
pH and alkalinity cannot be treated as the same thing. Water can have a high pH but a small reserve of bicarbonates, and then its reaction will change quickly once fertilizer is added. Conversely, water with a moderate pH but high alkalinity will gradually push the reaction of the substrate upward.
What matters most for plants is not a one-time pH number but how the water behaves with regular watering. High alkalinity can gradually raise the pH of the root environment over time and reduce the availability of iron, manganese, and other elements. In commercial greenhouse production, for most crops the target total alkalinity is roughly 30–100 mg/L expressed as calcium carbonate, but houseplants have different requirements.
Tap water
Tap water may contain:
- calcium and magnesium;
- sodium and chlorides;
- bicarbonates and carbonates;
- sulfates;
- residual disinfection products;
- sometimes iron, manganese, or other impurities.
Such water may be safe for people but is not always convenient for plants. With high mineral content the starting EC rises, and part of the "allowable" concentration of the future solution is already taken up by salts from the tap.
Hard water can leave a white crust on pots and leaves, clog small openings, and gradually raise the pH of the substrate. Calcium and magnesium are not harmful in themselves: they are essential plant nutrients. The problem arises when there is too much of them, when their ratio is wrong, or when an extra CalMag supplement is added at the same time.
Moderate hardness is often convenient for plants because the water already contains some of the calcium and magnesium. With very soft water or reverse osmosis water, these elements have to come from the fertilizer. Too much of one of them can hinder the uptake of the other because of competition between ions.
Bottled water
A label saying "natural" or "artesian" does not tell you whether the water suits plants. On the label, look at:
- total mineral content;
- calcium;
- magnesium;
- sodium;
- bicarbonates;
- sometimes pH.
For weak nutrient solutions, water with low or moderate mineral content is usually more convenient. Water with a lot of sodium is undesirable for regular watering: sodium does not replace calcium and magnesium for plants and can accumulate in the substrate.
Rainwater and snowmelt
Rainwater is usually soft and may be slightly acidic. However, water collected in a city comes into contact with the air, the roof, the gutter, dust, and the container. It can pick up organic contaminants, metal particles, road salts, and microorganisms.
For an indoor collection, rainwater is used only after assessing the collection site, the cleanliness of the container, and the stability of the source. It is better not to collect the first flush of a rain: it washes the accumulated dust off the roof surface. Store the water in a closed, clean container and do not use it if a smell, sediment, or film appears.
Reverse osmosis and distilled water
Reverse osmosis and distillation produce water with a very low content of dissolved substances. Such water is convenient when you want to build the solution yourself without accounting for unknown salts from the tap.
"Empty" water is not complete nutrition. With regular use of reverse osmosis water, the plant must get calcium, magnesium, and the other elements from the fertilizer. Some fertilizers are designed for soft water and already contain the necessary supplement; others require a separate CalMag.
After reverse osmosis it is important to monitor not only EC but also the composition of the solution. A low EC in itself does not guarantee correct nutrition: the meter shows total conductivity, not the ratio of elements.
Filters and boiling
A household filter improves water only within the limits of its design. A carbon filter can reduce the smell of chlorine and some organic impurities, but it does not turn hard water into reverse osmosis water. A water softener that works by replacing calcium and magnesium with sodium can make the water less hard by a household test, but it increases the sodium content.
Boiling sometimes reduces part of the temporary carbonate hardness, but it does not remove all dissolved salts. After boiling some of the minerals may precipitate, while some remain in the water. So boiling cannot be considered a universal way to prepare water for a collection.
How to choose water for your collection
| Situation | What to check or change |
|---|---|
| Plants grow steadily | Measure EC from time to time and watch for crust |
| White crust and drying leaf edges | Check EC, hardness, alkalinity, and sodium |
| The pH of the solution keeps rising | Assess the alkalinity of the water, not just its pH |
| Reverse osmosis water is used | Check that the fertilizer contains calcium and magnesium |
| The solution comes out too concentrated | Account for the EC of the source water and lower the fertilizer dose |
| Problems recur across the whole collection | Have the water analyzed by a laboratory |
To start with, it is enough to know the EC of your source water, its approximate hardness, and how the pH responds after fertilizer is added. If the water is unstable or plants are grown in coir, a mineral medium, semi-hydro, or a reservoir, an extended analysis becomes especially useful.
Water is considered suitable not by a single parameter, but by how predictably it works together with a particular plant, substrate, fertilizer, and watering routine.
Detailed explanations of root-zone pH, EC/ppm, salt buildup, and buffering are in the section "Root environment basics."