Thrips: Signs, Confirmation, and First Steps
Thrips are small insects with piercing-sucking mouthparts. They move quickly and often hide in the growing point, young furled leaves, leaf axils, buds, and flowers. With a small infestation the pest may go unnoticed, so diagnosis starts with inspecting the damage and looking for larvae.
What the damage looks like
Thrips scrape the surface of the cells and suck up the sap that comes out. Damaged areas first look like small pale streaks and scuffs, and then take on a silvery or grayish-brown tint.
The leaves may show:
- silvery stripes, trails, and patches;
- many small pale punctures;
- areas that look as if the surface has been scraped;
- dry mottling and loss of natural sheen;
- black dots next to the damage — the pest's droppings;
- uneven edges and deformation of young leaves;
- a curled or twisted new leaf;
- smaller size of the following leaves;
- slowed growth and death of individual patches of tissue.
Damage is more often noticeable on young leaves, since their tissues are softer. When thrips feed in buds and flowers, the petals may become covered with pale spots, and the buds may open incompletely or be deformed.
Where to look for thrips
Inspect the whole plant, paying special attention to places where the pest is protected from outside influences:
- the undersides of the leaves;
- the growing point;
- young furled leaves;
- the leaf axils and the bases of the petioles;
- buds and flowers;
- places where leaves touch;
- the surface of the substrate and hiding places near the pot;
- neighboring plants.
The larvae are usually pale — yellowish-white or cream — and move more slowly than the adults. Adult thrips are narrow and small, ranging from pale yellow to dark brown or almost black. Because of their size and fast movement, they are easily mistaken for particles of substrate.
How to confirm an infestation
For inspection, use a magnifying glass, your phone's macro camera, and a sheet of white paper.
Gently shake the plant or lightly tap the petioles over the paper. Look at the fallen insects under magnification. This method helps detect mobile adults and larvae, even if they quickly hide on the plant itself.
It is also useful to put blue or yellow sticky traps next to the plant. They do not replace inspection and treatment, but they help you notice flying adults and track how the numbers change.
A single sign does not always allow a definitive diagnosis. Silvery patches can also arise from mite damage, mechanical rubbing, or poor growing conditions. To confirm, compare the nature of the damage, the presence of black dots, the deformation of young leaves, and the results of looking for the pest.
First steps
When thrips are suspected, the plant is immediately isolated from the collection. At the same time the neighboring plants are inspected: adults can move between plants, and hidden stages can persist in buds, leaves, and hiding places.
The sequence of initial steps:
- Move the plant to a place separated from the main collection.
- Inspect the leaves on both sides, the growing point, the petioles, the leaf axils, the buds, and the flowers.
- Carefully rinse the leaves with lukewarm water, aiming the stream at the undersides and the petioles.
- Cover the substrate or hold the pot at an angle to avoid unnecessary waterlogging.
- After the shower, let the plant dry completely in a shaded, ventilated place.
- Remove badly damaged flowers and plant parts, if this is acceptable for the particular species.
- Wash the windowsill, shelf, cachepot, and tools.
- Record the date of detection and watch the plant daily.
A shower and mechanical rinsing reduce the number of mobile insects but do not destroy the eggs inside the tissue or the hidden stages. With a significant infestation, a full treatment scheme with a product registered against thrips is needed after the initial cleaning.
Potassium soap and mechanical cleaning
A lukewarm shower helps wash away some of the mobile thrips, larvae, sticky secretions, and dirt from the surface of the leaves. To strengthen the cleaning effect, diluted green (potassium) soap can be used.
The soap solution is applied to the leaves and petioles with a soft sponge or sprayed over the plant, paying attention to the undersides of the leaves, the leaf axils, and the growing points. Then the dirt is gently wiped off and thoroughly rinsed away with clean water. The soap solution is not left on the leaves for long: a dried film can increase the risk of spots and burns, especially on young or thin foliage.
Potassium soap helps remove some of the mobile pests, but it does not destroy the eggs inside the leaf tissue and does not replace a course of insecticide. Before use, check the instructions of the particular product: some products allow a film to be left on the plant, while for cleaning leaves the manufacturer explicitly recommends rinsing with water afterward.
The treatment is done without direct sun or strong heat. If the plant will be treated with an insecticide after the shower, let it dry completely. Potassium soap and an insecticide are not mixed unless their compatibility is explicitly stated on the labels.
Quarantine for new plants
A new plant is kept apart from the collection until observation is complete. It is inspected several times a week, especially after new leaves appear and buds open.
After shipping, a plant may temporarily stop growing, so individual damage does not always make it possible to identify the cause right away. However, quarantine does not replace inspection: thrips can stay unnoticed in the growing point and on young leaves for a long time.
Shipping, repotting, and treating with several products all at once make it hard to assess the plant's reaction. If there is no urgent threat, first record the condition, isolate the plant, and choose a step-by-step plan of action.
Inspecting the whole collection
When an infestation is confirmed, check more than just the plant with visible symptoms. Inspect the whole room, or at least the plants standing nearby and touching it with their leaves.
Pay special attention to:
- plants with young furled leaves;
- flowering plants;
- plants that recently joined the collection;
- species with a dense canopy and many hiding places;
- plants that already had similar silvery damage.
If thrips are found on several plants, treatment is planned for the whole contact group. Otherwise part of the population may survive on the neighbors and recolonize the plant that has already been cleaned.
When urgent treatment is needed
Do not postpone treatment if:
- new leaves are deformed one after another;
- silvery damage is spreading quickly;
- black dots appear on several leaves;
- the pest has been found in the growing point or buds;
- thrips have been found on several plants;
- the plant is losing turgor and growth rate;
- fresh damage appears again after a shower.
The product, application method, concentration, repeat interval, and compatibility are chosen according to the current label. For thrips, insecticides registered against this pest are used; acaricides intended only for mites do not replace such treatment.
The practical takeaway
Thrips are easier to detect by a combination of signs than by one damaged leaf. Silvery trails, black dots, deformation of young leaves, and pale mobile larvae call for isolating the plant and inspecting the whole collection.
The first shower reduces the number of pests and makes later treatment easier, but it does not cover all stages of their development. So once an infestation is confirmed, a step-by-step treatment scheme is drawn up, and the result is judged by the absence of new damage and the normal unfurling of the following leaves.